Snowglobe Tutorial

The snowglobe may look a little complicated at first but it is actually pretty easy as long as you realize that you have to connect the snowman first and then slide the top of the sphere together on each ring.  You will see below.  I labeled each piece as a letter to make it easier.  As far as A, B and C are concerned it DOES matter which order you go in.





BASE ASSEMBLY:

 
 First take the three base pieces (F, G, and H) Stack F onto G then onto H.  That will give you the shape above as seen from the bottom.  This creates the base support.
 Using outer ring "I" (the largest ring), take the base support and insert the cut out on the side into 2 of the ring slots.
Bend the base support in the very middle to give enough room to enter the opposite side of one of the ring supports.  Initially you will probably have multiple base supports in one slot in the ring, that's ok.  It makes it easier to separate later.  Then separate the base support to place the base supports into the other two slots on one side.  This should allow you to make the middle one straight as seen above.

Next separate the base supports on the opposite side to enter the slots.  You will need to bend them slightly to get them to fit in.  Once in you can straighten the cardstock.  Now the base is complete.

GLOBE ASSEMBLY:

First, paste the hat onto "A". Next grab piece "A" and "C" and insert the snowman of "C" into the gap of the snowman on "A" until the snowmen are matched up.
 Next slide the top of the rings together so that the slots match up at the top.

Now insert the snowman on B into the joined A C snowman.
Once it bottoms out slide the top of the ring together to fit into the top cutout.

Hold the ABC joined piece together as if they are on and bend it slightly along the cut lines in the snow man.  Place ring D (D and E are identical it doesn't matter which is which) into the two cutouts in the top of the joint section and ring E into the bottom two cutouts, to create what is seen above.

Separate the sides of the joint ABC to place them in the cutouts in ring D and E.  It's best to complete one side at a time so that the center can straighten out before you separate the other side.

Lastly repeat the last step for the other side to complete the sphere.
Lastly insert to cutout at the base of the sphere into the base.  It doesn't matter too much where, I usually like it to straddle piece F since it is solid on the top.
Viola!  You have a snow globe.  Unfortunately you'll have to stand in a snowstorm and shake hard to make the snowfall.  I couldn't figure out how to make that happen.  Any ideas?

4 comments:

  1. I don't know if this is an appropriate place to make requests, but I LOVE your designs. I just came across your stick figures. They are adorable, I especially like the ballerina. Any chance you could make one with a little boy and a toy train? What about a woman reading and a man/teenager playing a video game?

    ReplyDelete
  2. You are always welcome to make requests on here! I love to hear what you think. Great ideas. I will put them on the list.

    ReplyDelete
  3. The tree snowglobe is lovely but a little challenging... any chance we could get some intructions please??
    Thanks vicki

    ReplyDelete
  4. How do you recommend one to attach the charms to the 3d heart globe?

    ReplyDelete

Related Posts with Thumbnails